1. Install the lever of the lock and the lever of the selector. |
2. Install the directing plate on the support plate and fix by two bolts. |
3. Tighten bolts to the support plate. Inhaling moment: 6,9–9,8 N • m
|
4. Apply lubricant 0-GL02 on an internal part of a roller. |
5. Move the selector lever to a position P. |

|
6. Freely establish a spring plate, the top spring plate and a plate. |

|
7. Adjust a guide gap between a plate and a pin and tighten two screws. Inhaling moment: 2,0–2,9 N • m
|
8. Apply lubricant 0-GL02 on an internal part of the directing plate. |

|
9. Apply lubricant 0-GL02 on outer side of the directing plate. |
10. Install a selector lever position indicator lamp in the indicator panel. |
11. Establish a cover. |
|
12. Tighten the screw of fastening of the panel of the indicator in the sequence given on the drawing.
Inhaling moment: 2,0–2,9 N • m
|
13. Carry out O/D switch wires through a cover and the indicator. |
14. Insert an O/D switch wire into the socket. |
15. Screw two screws of fastening of the handle of the lever of the selector. Inhaling moment: 2,0–2,9 N • m
|
16. Check that position of the lever of the selector there correspond indications of the lever of the selector. |