10.6. Block of valves of management

Check


Prevention

Before removal of the block of valves clear the external surface of the transmission a cleaner or solvent.


PERFORMANCE ORDER
1. Support by special OK201 170 AA0 adaptation the engine.
2. Lift the car and fix on support.
3. Merge liquid from the transmission in a suitable container.
4. Turn out seven screws and remove the left and right mudguards of a motor compartment.
5. Turn out two nuts of fastening of a support No. 2 of the engine to the engine.
6. Turn out bolts and nuts and remove a plate of protection of the engine.
7. Turn out 19 bolts and remove the oil pallet and laying.
8. Disconnect all electric sockets, turn out eight bolts and remove the block of valves of management.

Installation

PERFORMANCE ORDER
1. Install the block of valves of management, fix by eight bolts and clips of wires.

Length of bolts:
And – 30 mm
In – 50 mm
Inhaling moment: 7,9-10,7 N of m

2. Install the oil mesh filter and fix by three bolts.

Inhaling moment: 7,9–10,7 N • m

3. Connect all electric sockets.

4. Clear the interfaced surfaces of the oil pallet and a case of the transmission of the remains of old laying. Install the oil pallet with new laying and fix by nineteen bolts.

Inhaling moment: 8,4-10,7 N of m

5. Establish a plate of protection of the engine and, freely screw bolts and nuts.

6. Tighten nuts And yes bolts In fastenings of a plate of protection of the engine.

Inhaling moment:
And – 38–51 N • m
In – 48–65 N • m

7. Establish the left and right mudguards of a motor compartment and fix everyone by seven screws.
8. Remove the special OK201 170 AA0 adaptation supporting the engine.
9. Take the probe for measurement of level of liquid and fill in necessary amount of the required liquid. Check liquid level in the automatic transmission during the operation of the engine at an idling rotation frequency.
10. Carry out a control trip and check lack of leaks in the places stated above.