14:11. Main brake cylinder
Main brake cylinder and vacuum amplifier of brakes
1 – socket of the sensor of level of brake fluid; 2 – tubes of the brake system; 3 – main brake cylinder; 4 – vacuum hose; 5 – a pin with a head and an opening under the forelock and a spring pin; |
6 – nut; 7 – vacuum amplifier of brakes; 8 – laying (to replace); 9 – unilateral vacuum valve |
Removal
PERFORMANCE ORDER |
1. Disconnect a wire from the negative plug of the rechargeable battery. |
2. Disconnect the socket of the sensor of level of brake fluid. |
 |
3. Disconnect two brake tubes from the main brake cylinder and close them plastic traffic jams, for an exception of hit of dirt in them. |
Prevention
Brake fluid dissolves paint, plastic and isolation of wires therefore at casual hit of liquid on a paint and varnish covering of the car or its components, wash out their large number waters.
|
4. If necessary, remove the brake pedal plug, a stopper and an overlay of a pedal of a brake. |
5. Remove the main brake cylinder. |
|
Installation
PERFORMANCE ORDER |
1. At installation of the new main brake cylinder adjust the provision of a pusher of the vacuum amplifier of brakes. |
2. Install the main brake cylinder on the vacuum amplifier of brakes and screw two nuts. |
3. Tighten two nuts of fastening of the main brake cylinder.
Inhaling moment: 9,8–16 N • m |
4. Connect two tubes of the brake system. |
5. Tighten nuts of fastening of tubes of the brake system.
Inhaling moment: 13–22 N • m |
6. Connect the socket of the sensor of level of brake fluid. |
7. Remove air from a hydraulic contour of the brake system. |
8. Connect a wire to the negative plug of the rechargeable battery. |
|