15.4. Forward stabilizer of cross stability

Forward stabilizer of cross stability

1 – nuts of fastening of an earring of the stabilizer;
2 – stabilizer earring;
3 – assembly bolt;
4 – stabilizer arm;
5 – stabilizer plug;
6 – stabilizer;
7 – nut of fastening of steering transfer

Removal

PERFORMANCE ORDER
1. Lift a forward part of the car and fix on support.
2. Remove a wheel.
3. Remove a mudguard of a motor compartment.
4. Turn out nuts and disconnect stabilizer earrings from the stabilizer.
5. Turn out nuts and disconnect stabilizer earrings from the lower levers of a forward suspension bracket.
6. Turn out two nuts of fastening of an arm of steering transfer and temporarily shift steering transfer.
7. Support by OK201 170 AA0 adaptation the engine and turn out six bolts of fastening of a cross beam.
8. Lower a cross beam so that it was possible to bring the stabilizer out of a cross beam.
9. Remove the stabilizer.

Installation

PERFORMANCE ORDER
1. Install the stabilizer plug according to the adjusting tags applied on the stabilizer.
2. Install the stabilizer behind a cross beam.
3. Lift a cross beam into place and fix by six bolts.

Inhaling moment: 93–127 N • m
4. Tighten two nuts of fastening of an arm of steering transfer.

Inhaling moment: 31–46 N • m
5. Install stabilizer earrings on the lower levers and fix them by nuts.

Inhaling moment: 43–61 N • m

Prevention

Tighten nuts of fastening of an earring of the stabilizer on the lower levers the required moment after installation of the car on wheels (under loading).