16:38. Dashboard


1 – overlay of the central console;
2 – central console;
3 – side cover;
4 – lower panel of finishing;
5 – top decorative overlay of the dashboard;
6 – combination of devices;
7 – control panel of heating and ventilation;
8 – radio receiver;
9 – ware box;
10 – central panel of finishing;
11 – dashboard set of switches and control devices

Removal

PERFORMANCE ORDER
1. Remove the central console.
2. Remove a safety cushion of the driver.
3. Remove a steering wheel, the turn signal switch, both the top and lower casings of a steering column.
4. Turn out a nut of fastening and exempt a cover of a cable of opening of the lock of a cowl from a plate on the left side of the dashboard.
5. Remove the handle of opening of the lock of a cowl. Turn out three screws and remove the finishing panel on the left side of the dashboard.
6. Turn out two bolts of fastening of the left side of the T-shaped connector.
7. Turn out two bolts of fastening of the left side of the dashboard, as shown in the drawing.
8. Remove an ashtray.
9. Remove an overlay of the central console.
10. Remove the control panel of heating and ventilation.
11. Remove a ware box.
12. Remove the central panel of finishing.
13. Remove a safety cushion of the forward passenger.
14. Turn out two bolts of fastening of the right side of the T-shaped connector.
15. Turn out two bolts of fastening of the right side of the dashboard, as shown in the drawing.
16. Turn out two bolts on both sides of a steering column which fix a steering column and the dashboard. Lower a steering column down.
17. Disconnect all sockets connecting the dashboard and a plait of wires of the car.
18. Remove the dashboard.

Installation

PERFORMANCE ORDER
1. Install the dashboard in the car.
Make sure that the steering column is established correctly through T-shaped draft with a plait of wires before installation of the dashboard. Otherwise the steering column cannot be correctly established.
2. Connect sockets of a plait of wires and the dashboard.
3. Screw two bolts on both sides of a steering column which fix a steering column and the dashboard.
      
Inhaling moment: 18–26 N • m
4. Screw three bolts of fastening of the right side of the dashboard.
      
Inhaling moment: 18–26 N • m
5. Screw two bolts of fastening of the right side of the T-shaped connector.
      
Inhaling moment: 18–26 N • m
6. Establish and fix a safety cushion of the forward passenger.
      
Inhaling moment: 18–26 N • m
7. Install the central panel of finishing.
8. Establish a ware box.
9. Install the control panel of heating and ventilation.
10. Establish an overlay of the central console.
11. Install an ashtray.
12. Screw two bolts of fastening of the left side of the dashboard.
      
Inhaling moment: 18–26 N • m
13. Screw two bolts of fastening of the left side of the T-shaped connector.
      
Inhaling moment: 18–26 N • m
14. Install the lower panel of finishing on the left side of the dashboard.
15. Establish the T-shaped connector and fix by two bolts.
16. Fix by a nut a cover of a cable of opening of the lock of a cowl to the dashboard.
17. Install the handle of opening of the lock of a cowl.
18. Establish a steering wheel, the turn signal switch, both the top and lower casings of a steering column.
19. Establish a safety cushion of the driver.
20. Install the central console.
21. Connect a wire to the negative plug of the rechargeable battery.