3c351ee6

18:11. Removal and installation of a starter

Starter

1 – socket S;

2 – top bolts of fastening of a starter;

3 – plug B

Arm of support of an inlet collector

 1 – top bolts;

2 – lower bolt

Removal
PERFORMANCE ORDER
1. Disconnect a wire from the negative plug of the rechargeable battery.
2. Turn out two top bolts of fastening of an arm of support of an inlet collector.
3. Disconnect the socket S.
4. Turn off a nut and disconnect a wire from the plug B.
5. Turn out two top bolts of fastening of a starter.
6. Lift the car and fix on support.
7. Turn out bolts and remove a reception exhaust pipe.
8. Turn out the lower bolt of fastening of an arm of support of an inlet collector.
9. Remove an arm of support of an inlet collector.
10. Turn out the lower bolt of fastening of a starter.
11. Remove a starter.

Installation

PERFORMANCE ORDER
1. Install a starter on the engine.
2. Screw the lower bolt of fastening of a starter.

Inhaling moment: 37–52 N • m
3. Connect a wire in the plug B of the traction relay and fix it by a nut.

Inhaling moment: 9–12 N • m
4. Connect the socket S.
5. Establish an arm of support of an inlet collector.
6. Screw three bolts of fastening of an arm of support of an inlet collector and tighten the lower bolt.

Inhaling moment: 37–52 N • m
7. Establish a reception exhaust pipe and fix by bolts.

Inhaling moment:
   And – 40,2–54,9 N • m
   In – 69–94 N • m
   With – 20,6–27,4 N • m
8. Lower the car.
9. Tighten two top bolts of fastening of an arm of support of an inlet collector.

Inhaling moment: 37–52 N • m
10. Screw two top bolts of fastening of a starter.

Inhaling moment: 37–52 N • m
11. Connect a wire to the negative plug of the rechargeable battery.