3c351ee6

18:19. Removal and installation of the generator

Removal

PERFORMANCE ORDER
1. Disconnect a wire from the negative plug of the rechargeable battery.
2. Remove a protective cap from the generator plug B.
3. Turn out a nut of fastening of a wire to the generator plug B.
4. Remove a wire from the generator plug B.
5. Disconnect generator sockets L and S.
6. Weaken the central bolt of fastening of the generator and an assembly bolt.
7. Rotating an adjusting bolt, weaken a generator drive belt tension.
8. Take off a drive belt from a generator pulley.
9. Turn out a bolt of fastening of a tension slip.
10. Turn out the central bolt of fastening of the generator.
11. Weaken a bolt of fastening of an adjusting plate and turn a plate.
12. Remove the generator from the engine. Remove the generator from the engine.

Installation

PERFORMANCE ORDER
1. Install the generator on the engine.
2. Screw, but do not tighten the central bolt of fastening of the generator.
3. Turn an adjusting plate in a starting position.
4. Establish an overlay of an adjusting plate.
5. Screw, but do not tighten a bolt of fastening of a tension slip.
6. Establish a generator drive belt on a generator pulley.
7. Rotating an adjusting bolt, adjust a generator drive belt tension.

Generator drive belt deflection
New 8–9 mm
Being in the use of 9-10 mm
8. Tighten a bolt of fastening of an overlay of an adjusting plate.

Inhaling moment: 19–26 N • m
9. Tighten the central bolt and a bolt of fastening of an adjusting plate.

Inhaling moment: 38–51 N • m
10. Connect L and S sockets to the generator.
11. Connect a wire to the generator plug B.
12. Fix by a nut a wire on the plug B.
13. Close the generator plug B a protective cap.
14. Establish an inlet air branch pipe and fix it by a collar.
15. Establish a zabornik of fresh air.
16. Screw forward bolts of fastening of a zabornik of fresh air.
17. Connect a wire to the negative plug of the rechargeable battery.

Prevention

Make sure that wires of the rechargeable battery are correctly connected.

Do not use high-voltage devices, like the megohm meter for check of resistance.

Remember that tension of the rechargeable battery always moves to the plug B of the generator of alternating current.

Do not connect to "weight" contact of L, during the operation of the engine.

Do not launch the engine while contacts of L and S are disconnected from the generator.