18:24. Spiral wire
Removal
Prevention
The socket of a spiral wire is an integral part of the combined switch and is not served as a separate part.
PERFORMANCE ORDER |
1. Remove a safety cushion of the driver. |
2. Turn out a nut of fastening of a steering wheel. Apply combination tags on a steering shaft and a steering wheel, for the correct repeated installation. |
3. A stripper, remove a steering wheel. |
4. Turn out three screws of fastening of a spiral wire, disconnect three sockets and remove the case of a spiral wire. |
|
Installation
PERFORMANCE ORDER |
1. Temporarily according to earlier put tags establish a steering wheel and establish forward wheels for the movement directly forward. |
Prevention
The centering finger is used alignments of the socket of a spiral wire at installation of a steering wheel on a steering column. The centering finger is delivered with the new combined switch and is necessary for installation of an original spiral wire. The centering finger has diameter of 3 mm and length of 76 mm.
|
2. Install the block of a spiral wire and fix by three screws.
Inhaling moment: 0,92 N • m |
3. Turn the central part of a spiral wire clockwise against the stop. Turn the central part of a spiral wire counterclockwise on 2 and 1/2 turns and combine arrows on the case and the central part of a spiral wire. |
4. Implant a centering finger into an opening from the face of the central part of a spiral wire so that it entered an opening from a reverse side of the case. |
5. Reinstall a steering wheel, having combined the tags put before removal and having passed an adjusting finger through an oblong opening in a steering wheel. Screw a nut of fastening of a steering wheel and tighten it the required moment.
Inhaling moment: 39–49 N • m |
6. Establish a safety cushion of the driver. |
|