 |
1. Apply a thin film of pure engine oil on the external surface of hydraulic compensators of gaps of valves. |
2. Install hydraulic compensators of gaps of valves on the places in a head of the block of cylinders. |
3. Check that hydraulic compensators of gaps of valves easily move in openings of a head of the block of cylinders. |
4. Grease with a thin layer of pure engine oil of a neck of camshafts and the working surfaces of bearings of camshafts. Install camshafts so that adjusting pins were directed up. |
5. Establish covers of bearings of camshafts according to numbering of covers. Shooters on covers have to be directed forward. |
6. Fix covers of bearings of camshafts by bolts, having tightened them in a certain sequence for 5–6 stages. Inhaling moment: 17,6–26,5 N • m
|
|
7. Grease the external surfaces and working edges of new sealing rings of camshafts with a thin layer of pure engine oil. |
 |
8. Using a tubular mandrel, the corresponding diameter, and the hammer establish sealing rings so that the end face of a sealing ring settled down flush with a head of the block of cylinders. |

|
9. Establish pulleys of camshafts, at the same time a tag of I on a pulley camshaft of inlet valves and a tag E on a pulley of the camshaft of final valves have to be combined with adjusting pins. Fix pulleys of camshafts by bolts.
Inhaling moment: 49–60,8 N • m |
 |
10. Install the sensor of an angle of rotation and fix it by bolts. |
 |
11. Establish a cover of a head of the block of cylinders and fix it by bolts.
Inhaling moment: 7,8–11,8 N • m
|
12. Establish a gear belt. |
13. Connect a hose of positive ventilation of a case and a hose of ventilation. |
 |
14. Establish high-voltage wires and coils of ignition. |
 |
15. Establish the top cover on a cover of a head of the block of cylinders and fix it by screws. Inhaling moment: 4,9–8,8 N • m
|
16. Connect a wire to the negative plug of the rechargeable battery. |