3.7. Oil pump

Removal

PERFORMANCE ORDER
1. Disconnect a wire from the negative plug of the rechargeable battery.
2. Turn out a stopper of discharge of oil and merge oil from the engine.
3. Take off a gear belt of the drive of the gas-distributing mechanism.
4. Pick up the oil pallet and the maslozaborny phone with the mesh filter.
5. Remove the generator.
6. Remove the compressor of the conditioner and an arm of the compressor of the conditioner.
7. Turn out a bolt of fastening of a pulley of a gear belt of a bent shaft.
8. Remove a pulley of a gear belt from a bent shaft.
9. Turn out bolts of fastening of the oil pump.

10. Remove the oil pump from the block of cylinders of the engine.

Installation

PERFORMANCE ORDER
1. Apply a continuous layer of sealant on the interfaced surface of the oil pump. After putting sealant it is necessary to install the pallet no more than in 5 min.
2. Oil engine a working edge of a new sealing ring and install it in the case of the oil pump.

3. Install the oil pump and fix by bolts.

Inhaling moments: 19–26 N • m

4. Establish a pulley of a gear belt on a bent shaft and fix by a bolt.

Inhaling moments: 156,8–166,6 N • m

5. Establish an arm of the compressor of the conditioner and the compressor of the conditioner and fix by bolts.
6. Install the generator.
7. Establish a maslozaborny tube with the mesh filter and the oil pallet.
8. Establish a gear belt of the drive of the gas-distributing mechanism.
9. Fill in necessary amount of the required engine oil in the engine.
;

10. Connect a wire to the negative plug of the rechargeable battery.

11. Launch the engine and check lack of leak of oil.
12. Check the level of engine oil and, if necessary, bring it to norm.