7.5. Ignition advancing corner
Change of installation of a corner of an advancing of ignition can be caused by two reasons: a problem with the sensor which will be found by the control unit of the engine or the wrong installation of the camshaft in relation to a bent shaft. The last problem is connected with the wrong installation of a gear belt of the drive of the gas-distributing mechanism.
No adjustment after replacement of the coil of ignition is required.
Check
PERFORMANCE ORDER |
1. Launch the engine and warm up it up to the normal working temperature. |
2. Switch off everything consumers of electric energy. |
3. Connect to the engine a tachometer and to a high-voltage wire of the first cylinder the stroboscope sensor. |
|
4. On combination of tags on a pulley of a bent shaft with the index, check an ignition advancing corner.
Ignition advancing corner: 8 ± 5 ° to VMT (at an idling rotation frequency)
|
Prevention
The corner of an advancing of ignition is not regulated.
|
|