8.12. Check of a flywheel

PERFORMANCE ORDER
1. Check a condition of a surface of friction of a flywheel for lack of cracks, a prigar and wear of a surface. Traces of insignificant development or a podgoraniye should be removed with an emery paper.
2. Check a condition of teeths of a gear wreath of a flywheel for lack of wear and a vykrashivaniye. If necessary, replace a gear wreath of a flywheel.

Installation

PERFORMANCE ORDER
1. Install by the hammer and a tubular mandrel the central bearing. Outer diameter of the bearing is 35 mm.
2. Clear a carving of bolts of fastening of a flywheel of the sealant remains. Before a vvorachivaniye of bolts, apply fresh sealant on a carving of bolts.
3. Establish a flywheel and special OK590 111 004 adaptation, block it from a provorachivaniye.
4. In a certain sequence tighten bolts of fastening of a flywheel.

Inhaling moment: 96,1–103,0 N • m

5. Clear vents in a nave of a clutch plate and apply on them a thin film of lubricant on the basis of a molybdenum disulfide.
6. Establish a clutch plate and center it a special mandrel OK130 160 010.
7. Establish a casing of coupling with a press disk on the directing flywheel pins.
8. Gradually, in the diagonal sequence and in a certain order tighten bolts of fastening of a flywheel.

Inhaling moment: 17,6–26,5 N • m

9. Install the transmission.